Kerf Width Matrix Lookup
View kerf width estimates by material, thickness, and nozzle, then approximate material loss for quote inputs.
Lookup
Nozzle records to compare
These matrix entries are planning inputs for comparison. Use the installed head record, approved cut chart, and a test coupon before selecting a production nozzle.
Kerf Width
Reference-matrix kerf
0.32 mm
Material Loss (from Kerf)
Linear Area Loss
32.00 cm^2
Volume Loss
9.60 cm^3
Mass Loss (steel)
0.075 kg
Override Workflow
Use the lookup value only until you have stronger shop evidence. Replace it with a measured kerf value when the job has a current cut chart, measured coupon, CAM compensation record, or first-article inspection result.
- Record material grade, thickness, nozzle, gas setup, focus, program feed, and machine ID.
- Cut a coupon or use a controlled first article, then measure the actual cut width.
- Update the quote input and CAM compensation after inspection approval.
Use when: nesting checks and CAM compensation when material, thickness, or nozzle setup changes.
Need the measurement workflow first? Read the kerf width guide before using this matrix in production quotes.
Reference-matrix input: This lookup returns a starting kerf input from the internal matrix. Confirm the value with your machine cut chart, test coupon, and first-article inspection before using it in a production quote.
Reference data governance
Last reviewed: 2026-04-27. Shop-measured kerf records, approved CAM compensation, and machine-specific cut charts should override this starting input when they are available.
Review methodology and assumptionsHow to use the kerf reference
The lookup provides a starting kerf input from material, thickness, and nozzle records, with an optional material-loss estimate for the entered cutting length.
Linear area loss = kerf width × cutting length. Volume and mass loss then use the entered thickness and a steel density assumption.
Kerf changes with power, speed, focus, gas, nozzle, and machine condition. A test coupon or approved cut chart should override this planning input for tight tolerances.